Domestic MB series planetary friction type continuously variable transmission: Nuoguang supplies MB continuously variable transmissions all over the country with power. Speed regulation range r/m output torque continuously variable transmission. Unified standard series of ordinary three-phase asynchronous motors. The motor adopts ~ Hz pure copper motor, if you need frequency conversion, braking, explosion-proof, variable frequency braking and other motors, please contact us or make a note yourself.
The basic type can be combined with any reducer (examples below)
, equipped with gear combination: MBBBBBB
, equipped with single-stage cycloidal pinwheel reducer combination: MB
, Combination with worm gear reducer: MB
, Combination with R series helical gear reducer: MB
, Combination with series helical gear worm gear: MB
, Combination with series helical gear bevel gear: MB
, equipped with series parallel axis helical gear combination: MB
, MB ceramic machinery special type
, equipped with two-stage gear combination: MB
, equipped with two-stage cycloid combination: MB< br/> Model representation method
Model example: MB.B
MB: Series code
: Horizontal installation (: vertical installation, flange installation)
: Machine base No.
: Three-phase asynchronous motor (if you need to customize other types of motors, please call us)
.: AC motor power.
B: Installation orientation
Speed range
Basic type: r/
Transmission with one-stage gear reduction (=.): r/
Transmission with two-stage gear reduction (=.): r/
Technical parameters
Input power:.~
Speed adjustment range: ~r/
Allowable torque
Speed adjustment method of continuously variable transmission: handwheel speed adjustment: divided into fast and slow handwheel and pointer hand Two types of wheels. Equipped with right-angle speed adjustment and electric speed adjustment.
Output display
, Speed handwheel: The number of revolutions cannot be seen directly
, Pointer handwheel: There is a deviation of d revolutions between the speed displayed on the pointer and the actual number of output shaft revolutions.
, Digital tester: The displayed speed is completely consistent with the actual output revolutions.
Installation, use and lubrication of MB type continuously variable transmission
1. Installation
When installing couplings, pulleys, sprockets, etc. on the output shaft, please do not hit it hard. Use the screw hole at the outer end of the output shaft to screw in the screw and press in the coupling.
When installing a base-type continuously variable transmission on a foundation, the installation centerline elevation, levelness and related dimensions of associated components should be calibrated. The coaxiality of the calibrated transmission shaft should not exceed the allowable value of the coupling. range.
The vertical MB continuously variable transmission can be installed at any angle. The oil level must exceed the center line of the oil mark on the higher side.
2. Use
Before use, designated lubricating oil should be added to the continuously variable transmission and reducer respectively
The temperature of the working environment of the MB continuously variable transmission does not exceed ℃, and the working oil The warm surface must not exceed ℃. For example, when the input speed is higher and the new machine is used, a slightly higher temperature rise will occur. After an hour of saturated operation, the temperature rise will gradually decrease. After that, the temperature rise will be higher than the ambient temperature °C and maintain a stable temperature rise
. The speed of the MB continuously variable transmission must be adjusted when it is turned on, otherwise the parts will be damaged
When the continuously variable transmission leaves the factory, the speed adjustment limit screw has been adjusted to the extreme position and must not be adjusted arbitrarily to avoid damaging the parts
br/>. The continuously variable transmission must not be used in excess of the rated torque
. The continuously variable transmission is suitable for forward and reverse operation
. If the motor is replaced, the motor flange with the original oil seal should be retained to avoid lubrication. Oil slides into the motor.
3. Lubrication
The special lubricating oil for MB continuously variable transmission must use b or b traction fluid. In any case, ensure that the traction fluid is provided in a quantitative amount according to the oil standard. After the transmission has been working for h, the traction fluid should be replaced, and then it should be replaced every h or so.
MBL07 continuously variable transmission combination RV worm gear reducer is the first choice when buying a reducer.